Make sure the contact area is clean and unpainted to provide good electrical contact to the E-timer. Inspect the timing cover where the timer rests.
MODEL T SPARKBOX NUTS SIZE FREE
Make sure it is clean and free from burrs around alignment pin hole. Remove roller/commutator nut, alignment pin retainer, alignment pin and old roller/brush from CAM shaft. Do NOT remove any coil wires from the timer yet. Remove timer case spring that holds timer to front of motor then move the old timer out of the way. Failure to follow these instructions can result in serious damage to the electrical system or car if an ignition wiring fault or other failure should occur. A 4A fuse must be installed when using the E. Verify ignition power positive battery wire is properly fused at the battery. Verify negative ground electrical system Negative battery terminal is connected to engine block. Important! Verify the ignition power is off. It is impossible to account for all possible mechanical alterations, mechanical wear or wiring changes that may have occurred over the years so these installation instructions include extra steps to verify proper mechanical fit and electrical performance to ensure trouble free installation and operation.
1 Installation Instructions The E- has been designed for installation on negative ground Model T engines in good mechanical condition operating from properly fused 6 to 12V battery power only. The E- will not fix engine problems due to carburetor issues, bad coils, incorrect wiring or lose electrical connections.
.jpg "model t sparkbox nuts size")
IMPORTANT! The E- should only be installed on Negative Ground Model T engines in good mechanical condition that run normally.
Failure to verify proper ignition timing may result in serious personal injury.
MODEL T SPARKBOX NUTS SIZE MANUAL
1 E Model T TM Installation and Operation Manual Sold by: Mictel LLC 244N 17 th Street Kenilworth, NJ web:Ģ Model T Electronic - E E Conversion Kit Contents The Electronic conversion kit contains the following items: Quantity Description 1 Electronic (E-timer) 1 Vane Actuator Assembly (Replaces Roller) 1 Alignment Pin Retainer ( brush cap ) 4 Fuse jumpers used to bypass coil points Spacer Shim (Not used in all installations) E - Vane Actuator Assembly Fuse Jumpers (4) Spacer Shim Alignment Pin Retainer E- Conversion Kit E- Patented: 8,662,058 V Mictel LLC 1ģ Model T Electronic - E IMPORTANT! It is the user s responsibility to verify proper ignition timing and ensure proper timing lever position before attempting to hand crank Model T engine with any model including the E.
0 kommentar(er)
